The full-color LED display LAN control scheme is the same as the single and double-color LAN control scheme. When the control card and the control terminal computer are in the same network IP address segment, they belong to the same network segment control. If the control card and the control terminal computer are not in the same network IP address segment It belongs to cross-network segment control.
For cross-network segment control, it is necessary to set a fixed IP address for the control card, and the IP address of the control card must be in the same network segment as the network where it is located.
IP address setting steps of full-color control card:
1. The control card is directly connected to the computer through the network cable, and the control card is powered on;
2. After the HDPlayer debugging software prompts that the device is found, click [Control]-[Device Information] in sequence;
3. In the "Network Settings" option, cancel the " Auto Obtain " function, and set the IP address information of the control card.
In addition, you can also open [Control] - [Other Settings] - [Network Settings] in turn to set the IP address of the control card.
The control terminal computer software HDPlayer of the cross-network segment control scheme needs to add the IP address of the control card .
Note: The full-color display LAN control scheme uses port 9527 for communication. If this port is disabled, the network administrator needs to update the network policy.